V45 '83 V45 SABRE, MAGNA ADDENDUM SWITCHES BRAKE AND TAIL SENSOR (V45 SABRE) Turn the ignition switch on. Check the source voltage at the black/brown lead. If there is no voltage, check and repair the source circuit. If there is voltage, measure the voltage at the white/ yellow (positive) and green/black (negative) wires. VOLTAGE: 5V If there is no voltage, replace the sensor unit. TAIL & STOP LIGHT FUEL PILOT LIGHT FUEL REMAINING -A---SENSOR TAIL & STOP /PILOT LIGHT TAIL & STOP SENSOR FUEL PILOT LIGHT CHECK UNIT IGNITION SWITCH FUEL PI LOT LAMP CHECK UNIT (V45 MAGNA) Turn the ignition switch ON and check the pilot light for operation. If the pilot high come on and go off after 2-3 seconds with the ignition on, the check unit is good. If the pilot light doesn't come on at all, check for the pilot light. If it is good, check for the unit. Make a circuit using pilot light (T7 3W), dry battery (12V) and the unit as shown. The pilot lights should come on and go off after 2-3 second. If the unit is good, check the wire harness for a open circuit. If the pilot light continue to light on with the ignition on, check for an amount of fuel in the tank or the stop and tail light. Fill the fuel tank or replace the stop and tail light if necessary and recheck. If the pilot light continue to light on yet, check the unit as shown above. If the unit is good, check for an short circuit in the wire harness. ®LAMP 3W (Fuel) BATTERY (12V) LAMP 3W (Tail/Stop) CHECK UNIT Date of Issue: October, 1982 0 HONDA MOTOR CO., LTD. 389 25 - 27