SWITCHES HONDA V45 CONTINUITY: BELOW OIL PRESSURE SWITCH 0.3 ± 0.1 kg/cm2 (4.3 ± 1.4 psi) Drain the engine oil. Disconnect the oil pressure switch lead and remove the switch. Check for continuity while applying pressure to the switch. Replace the switch if necessary. Apply a liquid sealant to the switch threads before installing the switch. Screw the switch in the crankcase and leave two threads from the bottom. Then tighten it to the specified torque. TORQUE: 15-20 N.m (1.5-2.0 kg-m, 11-14 ft-lb) NOTE: Do not over tighten the switch to prevent crankcase from damage. OIL PRESSURE SWITCH REAR BRAKE LIGHT SWITCH BRAKE LIGHT SWITCH Check the rear brake light switch for continuity with the rear brake applied. Check the front brake light switch for continuity with the front brake applied. Replace the switches if necessary. FRONT BRAKE LIGHT SWITCH 330 Date of Issue: May, 1982 0 HONDA MOTOR CO., LTD. 21-2