HYDRAULIC BRAKE SABRE MAGNA ASSEMBLY If the piston boots are hardened or deteriorated, replace them with new ones. The piston seals must be replaced with new ones whenever they are removed. Coat the seals with silicone grease ar brake fluid before assembly. Install the pistons with the dished ends toward the pads. Then install the piston boots. Install the cofiar boots and collar making sure that the boots are seated in the collar and caliper grooves properly. Install the pad spring and pads. COLLAR PISTON BOOTS BOOTS PIVOT BOLT l PISTONS OIL SEALS PAD SPRING COLLAR INSTALLATION Instail the pad spring on the caliper bracket as shown. Inspect the condition of the caliper pivot bolt boot. Apply silicone grease ar brake fluid to the caliper pivot bolt. Install the caliper assembly over the brake disc so that the disc is positioned between the pads. CAUTION: Be careful not to damage the pads.PIVOT BOLT BOOT CALIPER BRACKET PAD SPRING CALIPER PIVOT BOLT Install the caliper pivot bolt, if it is removed. TORQUE: 25-30 N•rn (2.5-3.0 kg-m, 18-22 ft-lb) Install the caliper bolt. TORQUE: 20-25 N•m (2.0-2.5 kg-m, 14-18 ft-lb) Connect the brake hose and fill the brake fluid reservoir. Bleed the front brake system (page 16-4). CALIPER BOLT 282 Date of Issue: May, 1982 C) HONDA MOTOR CO., LTD. 16-12