FRONT WHEEL/SUSPENSION V45 INSTALLATION Fit the calipers over the discs, taking care not to damage the brake pads. Install the caliper mounting bolts. TORQUE: 30-40 N.m (3.0-4.0 kg-m, 22-29 ft-lb) On the V45 SABRE, install the axle holder with the F arrow pointing forward. Loosely tighten the axle holder nuts and install the axle. FARROW SPEEDOMETER GEARBOX Align the speedometer gearbox with the tang on the left fork leg as shown. Tighten the axle to the specified torque. TORQUE: 55-65 N.m (5.5-6.5 kg-m, 40-47 ft-lb) 441 TANG ON FORK LEG Measure between the outside surface of the right brake disc and the inside of the right caliper holder with a 0.7 mm (0.028 in) feeler gauge. If the gauge cannot be inserted, pull the right fork out until the gauge can be inserted. On the V45 SABRE, torque the axle holder nuts, starting with the forward nut. TORQUE: 18-25 N.m (1.8-2.5 kg-m, 13-18 ft-lb) On the V45 MAGNA, tighten the axle pinch bolt to the specified torque. TORQUE: 15-25 N-rn (1.5-2.5 kg-m, 11-18 ft-lb) There should be at least 0.7 mm (0.028 in) clearance between the caliper holder and disc. CAUTION: After installing the wheel, apply the brakes several times and recheck the clearance on both sides. Failure to provide clearance will damage the brake discs and affect braking efficiency. Install the speed sensor wire or speedometer cable. a 0.7 mm (0.028 in) FEELER GAUGE 15-24 252 Date of Issue: May, 1982 © HONDA MOTOR CO., LTD.