HONDA V45 FRONT WHEEL/SUSPENSION UPPER HOLDER PUNCH MARK On the V45 MAGNA, place the handlebar onto the lower holder aligning the punch mark with the upper face of the lower holder. Install the upper holders, tighten the forward bolts first, then tighten the rear bolts. NOTE: 20-30 N•m (2.0-3.0 kg-m, 14-22 ft-lb) PUNCH MARK Install the front brake master cylinder with the "UP" mark on the holder facing up. Align the end of the holder with the handlebar punch mark (V45 MAGNA). Tighten the upper bolt first, then the lower bolt. Install the right handlebar switch and connect the brake light switch wires. PUNCH MARK Connect the choke cable to the choke lever and install the clutch master cylinder. Align the end of the holder with the punch mark on the handlebar (V45 MAGNA). Tighten the upper bolt first, then the lower bolt. Install the left handlebar switch and connect the clutch switch wires. Route the switch wires properly (page 1-9). 246 Date of Issue: October, 1982 0 HONDA MOTOR CO., LTD. 15-18