V45 DRIVE TRAIN GEAR CASE COVER STOP PIN FEELER GAUGE STOP PIN STOP PIN SHIM DRIVER 0-RING GUIDE 0-RING 07749-0010000 ATTACHMENT, 42 x 47 mm 07746-0010300 RING GEAR Remove the ring gear. If the clearance exceeds the limit, heat the gear case cover to approximately 80°C (176°F) and remove the stop pin by tapping the cover. Install a stop pin shim to obtain the correct clearance. SHIM THICKNESS: A 0.10 mm (0.004 in) B 0.15 mm (0.006 in) Install the shim and drive the stop pin into the case cover. Install a new 0-ring on the 0-ring guide. Apply grease to the 0-ring and drive the 0-ring guide onto the ring gear shaft. Install the ring gear into the gear case cover. Measure the clearance between the ring gear and the ring gear stop pin with a feeler gauge. CLEARANCE: 0.30-0.60 mm (0.012-0.024 in) WARNING Always wear gloves when handling the gear case after it has been heated. RING GEAR 221 Date of Issue: May, 1982 © HONDA MOTOR CO., LTD. 14-13