HONDA SABRE MAGNA TRANSMISSION OUTPUT GEAR CASE PRE LOAD INSPECTION TOOL 07998-4150000 WASHER Measure distance from the gear case mating surface to the bottom of the preload tool. Measure in three places. Then subtract the washer thickness from the distance measured. This will give you distance "A". Distance measured ( mm) washer thickness mm) = distance A STANDARD: 35.00 ± 0.10 mm (1.378 ± 0.004 in) Select the correct gasket thickness to obtain the standard distance A by using the formula below. DISTANCE A STD. GASKET DISTANCE THICKNESS REQUIRED + 0.05 mm) — 35 mm = NOTE: The addition of 0.05 mm is to compensate for the amount of gasket crush during assembly. Date of Issue: May, 1982 199 0 HONDA MOTOR CO., LTD. 1 3- 1 7