V45 TRANSMISSION Replace the driven gear adjustment shim with a thicker one if the contact is too low. DRIVEN GEAR/SHAFT The pattern will shift about 1.5-2.0 mm (0.06— 0.08 in) when the thickenss of the shim is changed by 0.10 mm (0.04 in). OUTPUT DRIVEN GEAR ADJUSTMENT SHIM: A: 0.04 mm (0.002 in) rT1 B: 0.20 mm (0.008 in) C: 0.25 mm (0.010 in) 06•••••• TOO LOW: D: 0.30 mm (0.012 in) STANDARD COUNTERSHAFT E: 0.35 mm (0.014 in) F: 0.40 mm (0.016 in) DRIVE F LANK FLANK COAST SIDE SIDE BACKLASH INSPECTION Place the output gear case in a vise with soft jaws or a shop towel. Set a horizontal type dial indicator on the countershaft as shown. Hold the driven gear with the shaft holder and rotate the countershaft by hand until gear slack is taken up. Turn the countershaft back and forth to read backlash. STANDARD: 0.08-0.23 mm (0.003-0.009 in) SERVICE LIMIT: 0.40 mm (0.016 in) SHAFT HOLDER 07923-6890101 Remove the dial indicator. Turn the countershaft 120° and measure backlash. Repeat this procedure once more. Compare the difference of the three measurements. DIFFERENCE OF MEASUREMENT SERVICE LIMIT: 0.10 mm (0.004 in) 197 Date of Issue: October, 1982 0 HONDA MOTOR CO., LTD 13-15