TRANSMISSION HONDA Remove the countershaft bearing holder bolts and holder from the case. Remove the output drive gear and shim. Place the countershaft/holder and a disassembly tool in a press. Press the countershaft out of the bearing holder. NOTE: Remove the center guide from the dis/ assembly tool before using it. COUNTERSHAFT BEARING REPLACEMENT NOTE: Countershaft must be removed before replac- ing bearing. Place the bearing holder in a vise with soft jaws or shop towel. NOTE: Do not damage the bearing holder, especially mating surface with the crankcase. Unstake the outer race lock nut with a punch. Remove the bearing outer race lock nut with a special tool. Discard the lock nut. LOCK NUT WRENCH, 30/64 mm 07916—MB00000 188 Date of Issue: May, 1982 © HONDA MOTOR CO., LTD. 13-6