V45 CRANKSHAFT/PISTON FRONT CYLINDER MARKS Coat the rod small end with molybdenum disulfide grease. Assemble the pistons and connecting rods with the pistons and piston clips as follows. Front cylinder connecting rod and piston assembly. Note that the front cylinder connecting rods are marked MBO "F". Install the pistons on the front connecting rods so that the intake "IN" mark is facing opposite the oil hole in the rod. REAR CYLINDER MARK Rear cylinder connecting rod and piston assenibly. Note that the rear cylinder connecting rods are marked MBO "R". Install the pistons on the rear rods so that the intake "IN" mark is facing the same direction as the oil hole in the rod. NOTE: Do not interchange the pistons, piston pins or connecting rods. Make sure that the piston pin clips are properly seated. OIL HOLES Align the hole in the connecting rod bearing insert with the hole in the connecting rod and install the insert. OIL HOLE Date of Issue: May, 1982 0 HONDA MOTOR CO., LTD. 179 12-13