HONDA 11. CRANKCASE SERVICE INFORMATION 11-1 CRANKCASE DISASSEMBLY 11-2 CRANKCASE ASSEMBLY 11-3 SERVICE INFORMATION GENERAL • To service the piston, crankshaft, connecting rod and transmission, the crankcase halves must be separated. • If a new crankcase is installed, perform countershaft shim selection procedures (Page 13-8). • Whenever the output gear case is removed, perform gasket selection procedures (Page 11-6). • The following parts must be removed before disassembling the crankcase. • Oil pan Refer to section 2 • Oil pump Refer to section 2 • Water pump Refer to section 6 • Clutch/starter clutch Refer to section 7 • Gear shift linkage Refer to section 8 • Alternator Refer to section 9 • Cylinder heads Refer to section 10 • Starter motor Refer to section 21 • Gear shift indicator switch TORQUE VALUES 9 mm bolt: 30-34 NI•rn (3.0-3.4 kg-m, 22-25 ft-lb) 8 mm bolt: 21-25 N.m (2.1-2.5 kg-m, 15-18 ft-lb) 6 mm bolt: 10-14 N•m (1.0-1.4 kg-m, 7-10 ft-lb) TOOLS Special Driver 07946-3710000 Common Attachment, 62 x 68 mm 07746-0010500 Pilot, 25 mm 07746-0040600 Date of Issue: October, 1982 Q-.) HONDA MOTOR CO., LTD 159