CYLINDER HEAD/VALVE V45 #1 INTAKE CAMSHAFT #1 EXHAUST CAMSHAFT Turn the crankshaft clockwise and align the T1.3 mark on the flywheel rotor with the rear crankcase mating surfaces. Position the #1, 3 camshafts so that they are positioned as shown. NOTE: The cylinders are numbered as shown below: FRONT PUNCH MARKS Align the punch marks on the rear cylinder cam sprockets with the top of the rear cylinder head. Place the cam chain on the sprockets. Position the cam sprockets on the camshaft flanges and loosely install the sprocket bolts. NOTE: Apply a locking agent to the threads and underside of the bolt heads before installa• tion. Install the camshaft holders. Do not torque the bolts until everything is installed and verified. Tighten the rear camshaft holder bolts in a crisscross pattern in 2-3 steps. TORQUE VALUES: 8 mm bolt: 20-25 N•m (2.0-2.5 kg-m, 14-18 ft-lb) 6 mm bolt: 10-14 N•m (1.0-1.4 kg-m, 7-10 ft-lb) NOTE: Tighten the intake camshaft holders first, then tighten the exhaust camshaft holders. INTAKE CAMSHAFT HOLDERS EXHAUST CAMSHAFT HOLDERS 154 Date of Issue: May, 1982 0 HONDA MOTOR CO., LTD.