V45 WU CLUTCH ASSEMBLY CAUTION: Handle the master piston, spring, primary cup and secondary cup as a set. Coat all parts with clean brake fluid before assemb ly. Install the spring, primary cup and piston. CAUTION: When installing the cups, do not allow the lips to turn inside out. Install the circlip making sure it is seated firmly in the groove. Install the boot and push rod. Install the clutch switch, if it was removed. RESERVOIR COVER MASTER CYLINDER CLUTCH SWITCH irri (tb PUSH ROD DIAPHRAGM HOLDER CLUTCH LEVER PIVOT BOLT SPRING PRIMARY CUP PISTON AND SECONDARY CUP CIRCLIP BOOT PUSH ROD END PIECE Place the master cylinder on the handlebar and install the holder and the two mounting bolts. Tighten the top bolt first then the bottom bolt. Install the oil hose with the bolt and its two sealing washers. Install the push rod end piece into the clutch lever hole and install the clutch lever. Connect the clutch switch wires to the switch terminals. Fill the reservoir and bleed the clutch system (page 7-4). OIL BOLT CLUTCH HOSE 105 Date of Issue: May, 1982 0 HONDA MOTOR CO., LTD. 7-7