V45 CLUTCH BLEED VALVE BLEED HOSE 1) Squeeze the clutch lever, open the bleed valve 1/2 turn then close the valve. NOTE: IDo not release the clutch lever until the bleed valve has been closed again. 2) Release the clutch lever slowly and wait several seconds after it reaches the end of its travel. Repeat the above steps until bubbles cease to appear in the fluid at the end of the hose. Fill the fluid reservoir to the upper level. OIL BOLT DISASSEMBLY Drain clutch fluid from the hydraulic system. Remove the rear view mirror and clutch lever. Disconnect the clutch switch wires and remove the clutch hose. CAUTION: Avoid spilling clutch fluid on painted surfaces. Place a rag over the fuel tank whenever the clutch system is serviced. NOTE: CLUTCH HOSE CLUTCH MASTER CYLINDER When removing the oil bolt, cover the end of the hose to prevent contamination and secure the hose. Remove the master cylinder. Remove the push rod boot, and circlip from the master cylinder body. SNAP RING PLIERS 07914-3230001 103 Date of Issue: January, 1982 0 HONDA MOTOR CO., LTD. 7-5