SABRE ENGINE REMOVAL/INSTALLATION ENGINE INSTALLATION Check the engine mount rubbers for damage and replace if necessary. Install the engine mount rubbers. Engine installation is essentially the reverse of removal. Use a floor jack or other adjustable support to carefully manuever the engine into place. CAUTION: Carefully align mounting points with the jack to prevent damage to mounting bolt threads and wire harness and cables. Tighten all fasteners to the torque values given on page 5-2. NOTE Route the wires and cables properly (Page 1-9 ). • Fill the crankcase to the proper level with the recommended oil (Page 2-1). • Fill the cooling system (Page 6-3). • Perform the following inspection and adjustments: Throttle operation (Page 3-6). Clutch (Page 3-18). Install the exhaust system: Install new exhaust pipe joint gaskets. Assemble the left and right exhaust pipes. Tighten the exhaust pipe band loosely and install the exhaust pipes. Hand tighten all bolts and nuts, then torque them in the order given below: 1. Tighten the exhaust pipe joint nuts. TORQUE: 8-14 N-m (0.8-1.4 kg-m, 6-10 ft-lb) 2. Tighten the exhaust pipe mounting side and bottom bolts. TORQUE: 8-12 N•m (0.8-1.2 kg-m, 6-9 ft-lb) 3. Tighten the rear muffler hanger setting bolts. TORQUE: 18-28 N-rn (1.8-2.8 kg-m, 13-20 ft-lb) 4. Tighten the exhaust pipe joint band bolts. TORQUE: 18-28 N.m (1.8-2.8 kg-m, 13-20 ft-lb) 80 Date of Issue: May, 1982 © HONDA MOTOR CO., LTD. 5-8