V45 MAINTENANCE CARBURETOR ADJUSTING ADJUSTING SCREW WRENCH 07908-4220201 LOCK NUT Synchronize to specification by loosening the adjusting screw lock nuts and turning the adjusting screws with the following tools: To adjust the No. 2, 4 carburetor — Carburetor adjusting wrench (07908-4220201) To adjust the No. 3 carburetor — Carburetor throttle adjusting bit (07908— MB00000) or (KS—AH-008—MBO, USA only) and Adjusting wrench (07708-0030200) or Snap-On Tool Wrench X0810 or equivalent available in U.S.A. Recheck the idle speed and synchronization. Remove the gauge adapters and install the plugs. Remove the clip from the automatic fuel valve vacuum tube. Reconnect the tube to the No. 1 cylinder. THROTTLE STOP SCREW CARBURETOR IDLE SPEED NOTE • Inspect and adjust idle speed after all other engine adjustments are within specifications. •The engine must be warm for accurate adjustment. Ten minutes of stop-and-go riding is sufficient. Warm up the engine, shift to NEUTRAL, and place the motorcycle on its center stand. Turn the throttle stop screw as required to obtain the specified idle speed. IDLE SPEED: 1,000 ± 100 rpm RESERVE TANK CAP RADIATOR COOLANT Remove the frame left side cover (V45 SABRE). Remove the frame right side cover (V45 MAGNA). Check the coolant level of the reserve tank with the engine runing at normal operating temperature. The level should be between the "FULL" and "LOW" level lines. If necessary, remove the reserve tank cap and fill to the "FULL" level line with a 50/50 mixture of distilled water and anti-freeze. Reinstall the cap and frame side cover. "FULL" MARK "LOW MARK 39 Date of Issue: October, 1982 CO HONDA MOTOR CO., LTD. 3-13