MAINTENANCE V45 IGNITION SYSTEM NOTE: The ignition system is transistorized and cannot be adjusted. If the ignition timing is incorrect, check the spark unit and pulse generator and replace any faulty parts (Section 20). Remove the alternator and left crankcase covers. Wipe off the oil from the flywheel. Connect the timing light to the high tension wire of the No. 1 cylinder. Start the engine and let it idle. IDLE SPEED: 1,000± 100 rpm The timing is correct if the "F" mark on the flywheel aligns with the crankcase rear mating surfaces. ALTERNATOR COVER LEFT CRANKCASE COVER "F" MARK REAR CRANKCASE MATING SURFACES VALVE CLEARANCE NOTE Inspect and adjust valve clearance while the engine is cold. (Below 35°C, 95°F) Drain coolant from engine and frame (page 6-3). NOTE Drain the coolant into a clean container for reuse. Scheduled coolant replacement is every 2 years or 24,000 miles (38,600 km). Remove the right and left frame side ccovers and remove the seat. Turn the fuel valve "OFF" (V45 MAGNA) and remove the fuel tank (V45 SABRE), Lift up the fuel tank by removing the front mounting bolts (V45 MAGNA). Be sure the tank is less than half full. If not, drain the tank. Remove the spark plug caps. SIDE COVER 36 Date of Issue: October, 1982 0 HONDA MOTOR CO., LTD. 3-10