HONDA MAINTENANCE MOUNTING BOLT Also, replace the element if it is excessively dirty, torn or damaged. Install a new element and install the cover. Disengage the tank support rod by lifting up slighty. Let the fuel tank down into place and install the fuel tank mounting bolts. Be careful not to pinch or kink the vent and fuel lines. CRANKCASE BREATHER Remove the plug from the drain tube to empty any deposits. Install the drain plug, NOTE: Service more frequently when riding in rain or at full throttle, or if the deposit level can be seen in the transparent section of the drain tube. SPARK PLUGS RECOMMENDED SPARK PLUGS NGK ND Standard DPR8EA-9 X24EPR-U9 For cold climiate DPR7EA-9 X22EPR-U9 (Below 5°C, 41°F) For extended DPR9EA-9 X27EPR-U9 high speed riding Disconnect the spark plug caps. Clean any dirt from around the spark plug bases. Remove and discard the spark plugs. Measure the new spark plug gaps using a wire-type feeler gauge. SPARK PLUG GAP: 0.8-0.9 mm (0.031-0.035 in) DRAIN PLUG CENTER ELECTRODE SIDE ELECTRODE (0.031-0.035 in) Adjust by bending the side electrode carefully. With the plug washer attached, thread each spark plugs in by hand to prevent crossthreading. Tighten the spark plugs another 1/2 turn with a spark plug wrench to compress the plug washer. Connect the spark plug caps. 35 Date of Issue: October, 1982 C) HONDA MOTOR CO., LTD. 3-9