LUBRICATION V45 OIL STRAINER CLEANING NOTE: The oil strainer can be removed with the engine rnounted in the frame. Remove the front exhaust pipes. Drain the engine oil (page 2-3). Remove the oil pan holts and oil pan. OIL FILTER OIL PAN Remove and clean the oil strainer. Check the operation of the pressure relief valve. Make sure the 0-ring is in good condition whenever the relief valve is removed. Instan the oil strainer and oil pan. Install the exhaust pipes. Fill the crankcase with the recommended oil (page 2-1). OIL STRAINER RELIEF VALVE 0-RING 1011- RELIEF VALVE OIL PRESSURE CHECK Warm the engine up to normal operating temperature (approximately 80°C/176°F). Stop the engine and disconnect the oil pressure switch wire. Remove the oil pressure switch and connect an oil pressure gauge to the pressure switch hole (page 2-5). Check the oil level. OIL PRESSURE SWITCH 18 Date of Issue: May, 1982 © HONDA MOTOR CO., LTD.